After upgrading my Yealink SIP-T22P to firmware 7.72.0.25, click-to-dial no longer worked. The command sent was:
http://192.168.17.12/servlet?number=1401...going_uri=
The phone display remained unchanged.
The web response from the phone was "200 OK".
The phone ignored the command and would not initiate a call as if the "Action URI allow IP List" had not been set properly. I confirmed this was set properly and looked for any other settings to enable remote control. I'm aware you have to confirm to allow remote control at the phone on the first try.
I downgraded to firmware 7.71.0.140 and click-to-dial worked again as expected. I'm sure the firmware was regression tested, so I'm puzzled why this didn't respond as expected. Any ideas?
Thanks!
http://192.168.17.12/servlet?number=1401...going_uri=
The phone display remained unchanged.
The web response from the phone was "200 OK".
The phone ignored the command and would not initiate a call as if the "Action URI allow IP List" had not been set properly. I confirmed this was set properly and looked for any other settings to enable remote control. I'm aware you have to confirm to allow remote control at the phone on the first try.
I downgraded to firmware 7.71.0.140 and click-to-dial worked again as expected. I'm sure the firmware was regression tested, so I'm puzzled why this didn't respond as expected. Any ideas?
Thanks!